RCCrawler Forums

Andyjk

Made these out of some ribbon from a craft store and some wire bent into shape with some pliers. Then use glue and thread to finish it off








Also made an aerial I used the below parts


And here they are together


I then glued the ball end and joint together and began to wrap a wire around the screw


For the top, I folded the wire back over on itself


Then got some heat shrink tubing and a small ball bearing. I widened one end of the heat shrink and placed the ball bearing inside


Then place it over the top of the wire and heat and mould into the correct spot






Here's a coat hanger aerial I made out of the same wire as above.


And a sand ladder made from a strip of aluminium with holes drilled. Then brushed over with a dremel



A simple bracket made from some thin steel



Photo of the thread added to tie down straps