| |
02-05-2020, 07:33 PM
| #1 |
| Newbie Join Date: Oct 2016 Location: JAPAN
Posts: 38
|  My Mountaineer mod
Hello. Last year, TAMIYA re-released mountaineer. Then I bought it. The fist concern point was, as well known, Rear Axle is longer than Front one. Therefore I followed YSS's solution. Drilled 2mm-size hole 10mm inside from original hole on Axle shaft (from RC4WD Hex Conversion kit). Each side of Axle is cut 8mm. Axle collars are cut 10mm. Hex hub (from RC4WD Hex Conversion kit) was difficult point. 0mm cut was insufficient, it hits screw. 5mm was maximum available cut. 2mm seems to be the best. Whole items Increased wheel hole size from 4mm to 5mm because inside of shaft thickness is 5mm. That seems Good! Last edited by AYA; 02-15-2020 at 05:15 AM. |
|  |
My Mountaineer mod - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Do you prefer the Chino mod over the O-Ring mod or vice-versa? | Digital | RC4WD Trail Finder 2 | 1 | 01-18-2018 02:22 PM |
| Front Dig Mod,steering mod & pushbar | TheButcher69 | General Crawlers | 1 | 11-06-2006 06:32 PM |
| Thread Tools | |
| Display Modes | |
| |
Threaded Mode
