RCCrawler Forums

themountain

Probably...a lot of ESCs behave differently with certain motors...you have to try

Rmendz

Any new info on this? Received an iflight Blitz w/ g071 mcu and want to try flashing to Am32. Thanks

haiso

Did you find it and does connection works in SW STM32CubeProgrammer ?

haiso

YES i DID it myself so connection works with SW STM32CubeProgrammer

themountain

On the Discord of AM32 is now a target list for ESCs which are not listed on the github page

botlebruiser

I'm new to blheli_32 and of course AM32 but I'm not new to outrunners. I bought a couple wraith32 v1s and I would like to get them setup for use on my 1/10 scale comp crawler. With that being said I'm curious if there is a better esc to use with small higher KV outrunners. I know lower KV is preferred but as I said I'm new and wondering if something like a 3450kv Micro Komodo would run on an esc that's overkill for its needs. I have an st programmer on the way but I already have an arduino. So my first question pertains to a specific esc that would perform well with a micro higher kv outrunner. My second question is how do I get an invite to am32.slack.com ?
I have tried to read through this thread. I apologize if I missed the answer to my question. Any help is appreciated.

themountain

I think the discord channel is more appropriate ...the slack is rather dead ----> https://discord.gg/h7ddYMmEVV For a 1/10 scale comp rig I think a micro outrunner like you mentioned isnt what you want ....I run a Holmes Hobby revolver with 1800 and 2040 kv and they are both great for their application . The wraith V1 esc have a not so great track report when it comes to being stable with 3or4s lipos...i would rather go with this https://www.aliexpress.com/item/1005...d=Rb3HkYt5TiLJ or this https://www.aliexpress.com/item/1005...d=eRpl6PeXFQ2g...they both have AM32 already installed

botlebruiser

I totally agree. I actually have a Holmes Hobbies v2 Team Spec revolver for my my 1/10 scale rig. I am also actively looking for a good AM32 esc to use with our 1/24 Scale comp trucks. I like the 3450 KV Micro Komodo but we are actively looking for an alternative to the Furitek motor. I will take a closer look at the discord. I appreciate your response and info.

cooper_xl

where? I've just joined Discord

cooper_xl

What are the ESC settings I should change? I have a Hakrc 35a with am32 and a 3535 1000kv 12t pinion on a Capra gearbox.

On slow starts in a climb motor starts to cog. I think I can gear it down to 10t. I'm using 2s but I can go 3s.

On the settings, already put bidirectional, correct number of poles and 1060kv because I can't dial to 1000