05-24-2021, 12:24 PM | #1 |
Newbie Join Date: Mar 2020 Location: Catasauqua
Posts: 25
| Pinion gear issue
I'm building the SSD Trail King and when getting to the assembly of the transmission, and attaching it to the motor, i ran into an issue, I opted to run the Hobbywing 550 AXE which has a 5mm shaft. The 16T gear that comes in the SSD kit has the smaller hole and will not mount to the shaft. I found 16Ts with 5mm hole however, the gear is much larger than the kit gear. What am I missing?
Last edited by Tima; 05-24-2021 at 12:55 PM. |
Pinion gear issue - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gear Ratio on Overdrive Pinion/Ring gear set? | Timmahh | SSD Trail King - Pro Scale Chassis Builder Kit | 1 | 08-09-2020 06:38 AM |
pinion gear and steel gear upgrade question (in the middle of installing, pleasehelp) | Sloalty | Redcat Crawlers | 3 | 05-23-2016 08:48 PM |
Pinion gear and ring gear mesh question | flyboy320 | Axial Wraith | 18 | 01-09-2016 02:41 PM |
Which pinion gear works best with RC4WD Steel spur gear? | e32lover | HPI Wheely King | 8 | 03-10-2013 06:09 PM |
Loose pinion gear/ possible engine issue | Habjinski | Newbie General | 5 | 07-06-2012 09:30 PM |
Thread Tools | |
Display Modes | |
| |