|
| LinkBack | Thread Tools | Display Modes |
12-24-2022, 06:58 AM | #1 |
Quarry Creeper Join Date: Nov 2020 Location: Greece
Posts: 384
| Troubleshooting a Fusion Pro 2300KV
I went ahead and installed the Fusion Pro on my TRX. Did all the pre-run procedures, went through the setup etc. I thought it was going to be a plug 'n play installation like my Axe, but no. It behaves very strange. Firstly, it seems to limit power once the throttle is fully pressed. Acceleration is normal up to a certain point, and then it just drops the wheelspeed. It even seems to stop and start again on straight lines. Kind like losing signal or power momentarily, but not exactly. While climbing, there have been situations that I could hear mechanical movement, but there was no wheelspin at all. So, I'm trying to understand what the issue is here, before I start tearing apart the rig. Is it a loose slipper clutch that causes this? Could it be overheating of the motor? If I keep a slow steady pace, everything work smooth as butter. |
Troubleshooting a Fusion Pro 2300KV - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hobbywing Quicrun Fusion Pro 2300kv 2-n-1 cogging? | Goro Majima | Electronics | 4 | 11-21-2022 11:39 PM |
New hobbywing quickrun fusion pro 2300kb | Alxe24 | Electronics | 45 | 07-25-2022 01:10 PM |
Mamba Max pro troubleshooting | Desmo | Electronics | 1 | 11-14-2017 09:48 AM |
Thread Tools | |
Display Modes | |
| |