|
| LinkBack | Thread Tools | Display Modes |
03-04-2023, 06:37 PM | #1 |
Quarry Creeper Join Date: Dec 2022 Location: Akron, Ohio
Posts: 256
| Steve's VS410 Phoenix Build II
Originally I was going to use this kit and part it out for my flatbed. But have decided to build it. I will build my flatbed at a later date. I started my axles and when I started the rear axle I wondered why I had just 3 5x11x4mm bearings when the instructions show 5. I wondered why the axles where out so far and saw the pin hole out so far with the end caps on. I preceded to install the bearings the way the opposing page showed and of course it all came together.
|
Steve's VS410 Phoenix Build II - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Steve's VS410 Phoenix Build | Steven McKay | Vanquish Products VS4-10 Origin | 173 | 04-26-2023 10:10 AM |
RedHarris's VS410 Phoenix Build | Redharris | Vanquish Products VS4-10 Origin | 1 | 11-20-2022 08:31 AM |
Woodys Vs410 Phoenix build. | KyWoody | General Crawlers | 2 | 03-17-2022 12:34 PM |
VS410 Phoenix? | Doomp | General Crawlers | 23 | 03-15-2022 08:13 AM |
Thread Tools | |
Display Modes | |
| |