|
| LinkBack | Thread Tools | Display Modes |
03-19-2023, 12:37 PM | #1 |
Newbie Join Date: Nov 2022 Location: Germany
Posts: 14
| VS4-10 Phoenix Problem with DIG
Sorry for starting a new thread but I couldn't find anything specific to this issue. I just build my VS4-10 Phoenix Portal kit and set my endpoints on my servos correctly however my DIG is very inconsistent. When I try to engage DIG the slider doesn't fully slip into the locker but instead gets stuck on the teeth, putting strain on the servo. Only a handful of times did it slide into the teeth and fully engage. I looked it over several times but can't seem to figure it out. I'm hoping someone can chime in and help me out?
|
VS4-10 Phoenix Problem with DIG - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
New - vs4-10 phoenix rtr | durok | Vanquish Products VS4-10 Origin | 22 | 02-12-2023 11:48 AM |
JDM’s VS4-10 Phoenix | JDM74 | Vanquish Products VS4-10 Origin | 10 | 09-30-2022 05:34 PM |
The new Vs4-10 Phoenix portal | Fricker08 | Vanquish Products VS4-10 Origin | 591 | 08-16-2022 07:43 PM |
Some Climbs with the Vanquish VS4-10 Phoenix | Airmaxx23 | Videos! | 1 | 11-07-2021 06:52 PM |
Vs4-10 Phoenix | easleycrawler | Vanquish Products VS4-10 Origin | 11 | 11-01-2021 07:44 AM |
Thread Tools | |
Display Modes | |
| |