RCCrawler Forums - BOM with 10-2 axles/trans?

RCCrawler Forums (http://www.rccrawler.com/forum/)

- G-Made Crawlers (http://www.rccrawler.com/forum/g-made-crawlers/)

- - BOM with 10-2 axles/trans? (http://www.rccrawler.com/forum/g-made-crawlers/631593-bom-10-2-axles-trans.html)

TrailDawg362

04-07-2023 05:16 PM

BOM with 10-2 axles/trans?

Hello, G-Made crew. As the title says, I'd like to convert the BOM to Axial 10-2 axles and trans. The plan is to use the existing chassis rails/crossmembers and keep the cantilever setup if possible. The goal is to get front overdrive and rear steer. Thoughts? Suggestions? Tips? Thanks for reading this far. :ror:

soze	04-07-2023 05:27 PM

Re: BOM with 10-2 axles/trans?

Should work I think. Go for it!

TrailDawg362

04-07-2023 05:37 PM

Re: BOM with 10-2 axles/trans?

Quote:

Originally Posted by soze (Post 6135250)

Should work I think. Go for it!

I thought it might be a fun build. The truck was barely used as is, and decided to try and revamp it rather than buying another rig for this summer. I have no axles on hand that can do rear steer, but other than that I should be ok.

OSRC	04-08-2023 07:58 AM

Re: BOM with 10-2 axles/trans?

BOM axles are wider than SCX10's. About 15-20mm IIRC. Will still work fine, just something to keep in mind.

TrailDawg362

04-08-2023 11:16 AM

Re: BOM with 10-2 axles/trans?

Quote:

Originally Posted by OSRC (Post 6135277)

BOM axles are wider than SCX10's. About 15-20mm IIRC. Will still work fine, just something to keep in mind.

Thanks for the tip, every little bit helps. It looks as though I'll have to lose the cantilever setup in order to do rear steer. Unless I get super creative and have a remotely located servo and linkage.

All times are GMT -6. The time now is 09:30 PM.