|
| LinkBack | Thread Tools | Display Modes |
04-07-2023, 05:16 PM | #1 |
Rock Slayer Join Date: Jul 2008 Location: Fox Valley WI
Posts: 1,684
| BOM with 10-2 axles/trans?
Hello, G-Made crew. As the title says, I'd like to convert the BOM to Axial 10-2 axles and trans. The plan is to use the existing chassis rails/crossmembers and keep the cantilever setup if possible. The goal is to get front overdrive and rear steer. Thoughts? Suggestions? Tips? Thanks for reading this far. |
Sponsored Links | |
04-07-2023, 05:27 PM | #2 |
I wanna be Dave Join Date: Aug 2016 Location: Orange County, CA
Posts: 3,611
| Re: BOM with 10-2 axles/trans?
Should work I think. Go for it!
|
04-07-2023, 05:37 PM | #3 |
Rock Slayer Join Date: Jul 2008 Location: Fox Valley WI
Posts: 1,684
| Re: BOM with 10-2 axles/trans? |
04-08-2023, 07:58 AM | #4 |
I wanna be Dave Join Date: Sep 2011 Location: Douglassville, PA
Posts: 4,030
| Re: BOM with 10-2 axles/trans?
BOM axles are wider than SCX10's. About 15-20mm IIRC. Will still work fine, just something to keep in mind.
|
04-08-2023, 11:16 AM | #5 |
Rock Slayer Join Date: Jul 2008 Location: Fox Valley WI
Posts: 1,684
| Re: BOM with 10-2 axles/trans? Thanks for the tip, every little bit helps. It looks as though I'll have to lose the cantilever setup in order to do rear steer. Unless I get super creative and have a remotely located servo and linkage.
Last edited by TrailDawg362; 04-08-2023 at 01:30 PM. |
Thread Tools | |
Display Modes | |
| |